A report listing individual bore diameters does not establish whether a hole pattern meets its geometric requirement. Buyers can prevent a second inspection by specifying how the supplier should identify and report the mounting holes under the released drawing.
Use consistent hole IDs on the drawing and report. Size may matter for a pin or bolt fit, while a separate position requirement controls where the feature lies relative to the specified references. Copy the governing callout and revision rather than inventing a simplified requirement for the inspection worksheet.
Identify the mounting face and any locating features specified by the drawing. Ask the inspector to record the datum sequence used, especially when several similar features could be picked on the model. Do not substitute an arbitrary best fit simply because it produces a cleaner result.
Request characteristic ID, nominal requirement, actual result and disposition in a stable format. Specify whether all holes in a pattern are checked on a sampled part and how the sampled part is identified. If assembly with a mating plate is also required, record that as a separate check.
If a repeat order moves to another inspection setup, explain how to preserve the datum setup during fixture transfer so the hole-pattern results remain comparable.
See our dimensional inspection and reporting process when setting the required report format.
Technical reference: ASME Y14.5 guidance.