Prevent ambiguous inspection reports by separating bore size from form and agreeing on section locations.
A diameter measurement describes size using a stated method. A roundness measurement evaluates the form of a circular section. A supplier should not use a diameter reading as evidence that an independently specified roundness tolerance passed. If the concern is the entire length of a cylindrical surface, ask whether the drawing also calls for a separate form assessment over that length.
Specify the sections to be evaluated, such as near each end and at a defined intermediate location, avoiding lead-ins unless the drawing includes them. Agree on the method and relevant evaluation settings before comparing results from different instruments. For a compliant part, state whether it is checked free or in a defined fixture, and have the report record that condition.
Agree the measurement decision rules for part acceptance and review our dimensional inspection and reporting process before requesting a quotation.
Technical reference: Mitutoyo’s roundness and cylindricity system reference.