Make a roughness requirement reproducible by identifying the functional land, trace direction and reporting settings.
Identify the functional band
Point the callout to the actual contact band rather than the entire shaft. A lead-in chamfer, transition or runout groove may have a different function. Where the contact band is narrow, check that the intended measuring path can stay within the surface to which the requirement applies.
Agree on the evaluation details
Name the roughness parameter and applicable specification, and agree on trace direction and evaluation settings with inspection. A trace along the machining marks need not give the same result as a trace crossing them. Where defects or directional lead are also important, define their acceptance separately instead of expecting a single roughness number to describe them.
What to put in the RFQ
- Mark trace start and end
- agree on access and the measuring method
- report the parameter, result, direction and settings used.
Technical reference: Mitutoyo’s guide to surface roughness measurement.