“Remove all burrs” is a useful intention but an incomplete acceptance instruction for many machined components. It leaves unanswered how much material may be removed, which edges must retain their geometry and how the result will be inspected. A more useful drawing separates general handling edges from features that locate, seal or engage with another component.
Classify edges by their function
Begin with an annotated view showing accessible outer edges, internal intersections and function-sensitive features. A broad instruction may be adequate for a noncritical external edge, while a sealing boundary or small locating shoulder needs a more specific requirement. Ask the design owner to identify exceptions instead of leaving the deburring operator to infer them from the shape.
Consider the complete part, including cross-holes and recessed features. If an internal intersection cannot be seen directly, decide how its condition will be established. The method should fit the requirement and the available access. Do not specify an inspection that cannot reach the feature, then accept a general visual sign-off as equivalent evidence.
Distinguish an edge break from a defined chamfer
The ISO abstract for ISO 13715:2017 describes indication and dimensioning of undefined edges. It separately points to general dimensioning principles when a geometrically defined shape is required. This is a useful distinction during drawing review: an edge that merely needs an agreed condition should not be confused with a controlled chamfer or radius.
If a chamfer guides assembly or forms part of a sealing interface, dimension the required geometry through the drawing system your organization uses. If the shape may vary within an approved edge requirement, specify that requirement and its exceptions. Have the drawing authority select the correct notation. A supplier should not silently reinterpret a general deburring note as permission to alter a functional feature.
Protect adjacent surfaces and small details
Identify nearby surfaces that must remain within their finished requirements. Include thin walls, narrow lands, fine threads and cosmetic areas where applicable. Ask the supplier to explain any feature that cannot be deburred without changing an adjacent dimension. Resolve this during DFM, when access or sequence can still be adjusted, rather than after a batch has been completed.
Agree the manufacturing stage for inspection. A feature accepted before a later machining operation may need to be checked again if that operation creates a new edge. Surface finishing can also change what the inspector sees. The purchase specification should state the final condition in which the component is accepted and distinguish any intermediate checks used to control the process.
Turn appearance expectations into a reviewable standard
For visual requirements, define the viewing conditions and the features to inspect. Where photographs or boundary samples are useful, identify their revision and the requirement they illustrate. A photograph should support the drawing, not create an undocumented alternative acceptance limit. If magnification is required, agree it explicitly so the supplier and receiving team assess the same condition.
For dimensional edge requirements, identify a suitable measurement approach with the inspection team. Keep acceptance criteria separate from a preferred production process. A supplier may have several ways to produce an acceptable edge, but the delivered condition must satisfy the same requirement. Record any approved deviation and its scope instead of treating a temporary concession as the next order's default.
Drawing-release checklist
- Classify general edges and function-sensitive exceptions.
- Define controlled chamfers or radii where geometry matters.
- Identify internal intersections and inspection access.
- Protect adjacent dimensions, surfaces and small features.
- Specify final inspection condition and viewing requirements.
- Control reference samples, photographs and approved deviations.
Coordinate edge acceptance with the surface-finish specification for machined parts. A clear package gives manufacturing freedom where it is useful while protecting the features that determine assembly performance.